Configuring Basic Is-Is; Configuration Prerequisites; Enabling Is-Is - HP VSR1000 Configuration Manual

Tasks at a glance
(Optional.)
•
Specifying the interval for sending IS-IS hello packets
•
Specifying the IS-IS hello multiplier
•
Specifying the interval for sending IS-IS CSNP packets
•
Configuring a DIS priority for an interface
•
Enabling source address check for hello packets on a PPP interface
•
Disabling an interface from sending/receiving IS-IS packets
•
Enabling an interface to send small hello packets
•
Configuring LSP parameters
•
Controlling SPF calculation interval
•
Configuring convergence priorities for specific routes
•
Setting the LSDB overload bit
•
Configuring the ATT bit
•
Configuring the tag value for an interface
•
Configuring system ID to host name mappings
•
Enabling the logging of neighbor state changes
•
Enabling IS-IS ISPF
•
Enabling prefix suppression
•
Configuring IS-IS network management
(Optional.)
•
Configuring neighbor relationship authentication
•
Configuring area authentication
•
Configuring routing domain authentication
(Optional.)
(Optional.)
(Optional.)

Configuring basic IS-IS

Configuration prerequisites

Before the configuration, complete the following tasks:
Configure the link layer protocol.
•
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.

Enabling IS-IS

Step
1. Enter system view.
2. Create an IS-IS process and enter
its view.
Tuning and optimizing IS-IS
Enhancing IS-IS network
Configuring IS-IS GR
Configuring BFD for IS-IS
Configuring IS-IS FRR
networks:
security:
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
131
Remarks
N/A
By default, the IS-IS process is
disabled.