Configuring The Lsu Transmit Rate - HP VSR1000 Configuration Manual

Enable SNMP notifications for OSPF to report important events.
•
• Configure the SNMP notification output interval and the maximum number of SNMP notifications
that can be output at each interval.
SNMP notifications are sent to the SNMP module, which outputs SNMP notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management and
Monitoring Configuration Guide.
To configure OSPF network management:
Step
1. Enter system view.
2. Bind OSPF MIB to an
OSPF process.
3. Enable SNMP
notifications for OSPF.
4. Enter OSPF view.
5. Configure the SNMP
notification output
interval and the
maximum number of
SNMP notifications that
can be output at each
interval.

Configuring the LSU transmit rate

Sending large numbers of LSU packets affects router performance and consumes too much network
bandwidth. You can configure the router to send LSU packets at a proper interval and limit the maximum
number of LSU packets sent out of an OSPF interface each time.
To configure the LSU transmit rate:
Step
1. Enter system view.
2. Enter OSPF view.
Command
system-view
ospf mib-binding process-id
snmp-agent trap enable ospf
[ authentication-failure | bad-packet |
config-error | grhelper-status-change |
grrestarter-status-change | if-state-change
| lsa-maxage | lsa-originate |
lsdb-approaching-overflow |
lsdb-overflow | neighbor-state-change |
nssatranslator-status-change | retransmit |
virt-authentication-failure | virt-bad-packet
| virt-config-error | virt-retransmit |
virtgrhelper-status-change |
virtif-state-change |
virtneighbor-state-change ] *
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
snmp trap rate-limit interval trap-interval
count trap-number
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
86
Remarks
N/A
By default, OSPF MIB is bound
to the process with the smallest
process ID.
By default, SNMP notifications
for OSPF is enabled.
N/A
By default, OSPF outputs up to
seven SNMP notifications
within 10 seconds.
Remarks
N/A
N/A