Ipv6 Is-Is Configuration Examples; Ipv6 Is-Is Basic Configuration Example - HP VSR1000 Configuration Manual

Task
Display IPv6 IS-IS routing information.
Display IPv6 IS-IS topology information.

IPv6 IS-IS configuration examples

IPv6 IS-IS basic configuration example

Network requirements
As shown in
same AS. Configure IPv6 IS-IS on the routers so that they can reach each other.
Router A and Router B are Level- 1 routers, Router D is a Level-2 router, and Router C is a Level- 1 -2 router.
Figure 95 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IPv6 IS-IS:
# Configure Router A.
<RouterA> system-view
[RouterA] isis 1
[RouterA-isis-1] is-level level-1
[RouterA-isis-1] network-entity 10.0000.0000.0001.00
[RouterA-isis-1] address-family ipv6
[RouterA-isis-1-ipv6] quit
[RouterA-isis-1] quit
[RouterA] interface gigabitethernet 1/0
[RouterA-GigabitEthernet1/0] isis ipv6 enable 1
[RouterA-GigabitEthernet1/0] quit
# Configure Router B.
<RouterB> system-view
Figure 95, Router A, Router B, Router C, and Router D, all enabled with IPv6, reside in the
Command
display isis route ipv6 [ ipv6-address ] [ [ level-1 | level-2 ] |
verbose ] * [ process-id ]
display isis spf-tree ipv6 [ [ level-1 | level-2 ] | verbose ] *
[ process-id ]
413