Removing A Memory Module - Toshiba TECRA A10 Satellite Pro S300 Series User Manual

■
■
8. Seat the memory module cover in place and secure it with one screw.
Take care to ensure that the memory module cover is firmly closed.
9. Install the battery pack - refer to
10. Turn your computer over.
11. Turn the computer on and make sure the added memory is recognized

Removing a memory module

To remove the memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
2. Remove the AC adaptor and all cables and peripherals connected to
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Downloaded from LpManual.com Manuals
User's Manual
The slot A is reserved for the first memory module. Use the slot B for
expanded memory. If only one module is installed, use the slot A.
When inserting or removing memory modules, use the A and B marked
on the computer chassis to determine which slot is A and which is B.
Align the grooves along the edges of the memory module with the
locking tabs on the connector and insert the module into the connector
firmly - if you find it difficult to install the memory module, gently prise
the locking tabs outwards using the tip of your finger.
Please also ensure that you hold the memory module along its left and
right hand edges - the edges with the grooves in.
Figure 3-10 Seating the memory module cover
Chapter 6, Power and Power-Up Modes, if required.
- to confirmed it, Start -> Control Panel -> System and Maintenance -
> System icon.
the Turning off the power
required).
the computer.
Replacing the battery pack
Modes, if required).
Hardware, Utilities and Options
Replacing the battery pack
section in Chapter 1, Getting Started if
section in Chapter 6, Power and Power-Up
Memory
module cover
Screw
section in
3-27