Toshiba TECRA A10 Satellite Pro S300 Series User Manual page 88

5. Loosen the one screw securing the memory module cover in place -
6. Slide your fingernail or a thin object under the cover and lift it off.
7. Push the latches away from the module in order to release it - a spring
8. Grasp the module by its edges and remove it from the computer.
■
■
9. Seat the memory module cover in place and secure it with one screw.
Take care to ensure that the memory module cover is firmly closed.
10. Install the battery pack - refer to
11. Turn your computer over.
Downloaded from LpManual.com Manuals
User's Manual
please note that this screw is attached to the cover in order to prevent it
from being lost.
will force one end of the module up at an angle.
If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
Figure 3-11 Removing the memory module
Chapter 6, Power and Power-Up Modes, if required.
Hardware, Utilities and Options
Latches
Replacing the battery pack section in
3-28