Base Settings; Dial Type; Change The System Pin Code; Paging (Find The Handset) - VTech VT1050 User Manual

Base Settings

Dial Type ( Preset to TONE )
Change the dial mode
1. Press and / to select BS SETTINGS.
• If the new
PIN entered 2. Press and / to select DIAL MODE.
in Step 6 is
3. Press and / to select TONE or PULSE.
not matched
4. Press to confirm.
with the new

Change the system PIN Code

system PIN
entered in
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to protect your
Step.
phone against unauthorized use. The default system PIN code is 0000.
1. Press and / to select BS SETTINGS.
•
If there is
2. Press and / to select CHANGE PIN.
an incoming
3. Press and you are requested to enter the 4-digit system PIN.
call during
4. Enter the old system PIN.
paging, the
phone will
5. Press and enter the new system PIN.
ring with the
6. Press and enter the new system PIN again.
incoming call
7. Press to confirm.
instead of

Paging (Find the Handset)

paging.
You can locate the handset by pressing
produce the paging tone and "PAGING..." is displayed on the LCD. You can stop the paging by pressing
any handset or on the base again.
19
on the base station. All the handsets registered to the base will
on