User Attendance Messages - Lexmark X203N Service Manual

User attendance messages

The printer control panel displays messages describing the current state of the printer and indicates possible
printer problems that must be resolved. This topic provides a list of all printer messages, explains what they
mean, and tells how to clear the messages.
The following table lists the messages in alphanumerical order. A message can also be located using the index.
User status and attendance messages
User primary message
Close Door
Insert Tray <x>
No Analog Phone Line
Memory Full, cannot
send faxes
Fax Station Name not set
up
Fax Station number not
set up.
Insert Duplex Page in
Tray <x>
Install Tray <x> or Cancel
job
Load <source> <custom
string>
Load <source>
<custom type>
Load <source>
<size>
Load <source>
<type> <size>
Message clears when upper and lower doors are closed.
This message is displayed when the printer requests the user to insert tray x
before it can continue printing the job. The printer needs to pick media from the
missing tray or the trays below it.
Tray x=Tray 1
Note: This message displays when refilling the trays during a job. Before filling tray
a tray, take the printer offline by pressing Stop
feeding into the output bin.
The following actions can be taken:
• Insert the requested tray.
• Cancel the current job
An analog line is not detected as being plugged into the modem. If the device is in
Analog mode, this has a source of Fax.
After a start, there is no memory to do the fax job. Attempted fax is canceled.
Setup fax name. See the user guide for more information.
Setup fax number. See the user guide for more information.
Reload printed page in tray <x>. Cancel Job appears if the job can be canceled.
Printer detects that tray <x> is missing, where x is 1 or 2. This message appears if
the job was begun, but the paper has not yet been retrieved. The tray is no longer
detected. Replace the indicated tray.
Printer does not detect media meeting the description <custom string> in
<source>, where <source> is Tray 1,Multi-Page Feeder (MP feeder), or Envelope
Feeder.
• Load the input source with the correct type and size media.
• Cancel the current job.
Printer does not detect media meeting the description <custom type> in <source>,
where <source> is Tray 1 .
• Load the input source with the correct type and size media.
• Cancel the current job.
Printer does not detect media meeting the size requested in the source indicated.
• Load the input source with the correct type and size media.
• Cancel the current job.
Printer does not detect media meeting the size or type requested in the source
indicated.
• Load the input source with the correct type and size media.
• Cancel the current job.
Explanation
, and wait for pages to stop
Diagnostic information
7011-2xx
2-19