Gap Adjust; Auto Dark Adjust; Reports; Main Setting's Page - Lexmark X203N Service Manual

7011-2xx

Gap Adjust

Adjusts the minimum gap between sheets during printing. This setting reduces speed (pages per minute), but
can be used to reduce curl of printed media and improve stacking in the output bin.
The range is 0 (default) to 255. Adjusting by one results in 9 mm of increased gap.

Auto Dark Adjust

This setting attempts to optimize the amount of toner used when printing with a specific operating point. Each
time this setting executes, the printer performs the following:
•
•
•
•
•
•
No messages are displayed on the operator panel to give any indication that this test is running. When
deactivated, the printer disables.

Reports

Main setting's Page

To print the Menu setting's Page:
1.
Select Reports from Diag Menu, and press Select (
2.
Select Menu setting's Page, and press Select (

Event Log

Display Log

The event log provides a history of printer errors. It contains the 12 most recent errors that have occurred on the
printer. The most recent error displays in position 1, and the oldest error displays in position 12 (if 12 errors have
occurred). If an error occurs after the log is full, the oldest error is discarded. Identical errors in consecutive
positions in the log are entered, so there may be repetitions. All 2xx and 9xx error messages are stored in the
event log.
To view the event log:
1.
Select EVENT LOG from Diag Menu, and press Select (
2.
Select Display Log, and press Select (
Up to three error codes display at a time. press
additional details.
Press Back (

Print Log

Additional diagnostic information is available when you print the event log from DIAGNOSTICS rather than
CONFIG MENU.
The Event Log printed from DIAGNOSTICS includes:
3-10
Service Manual
Calibrates its toner density sensor
Measures the reflectivity of its bare drum
Prints patches on the drum and measures the drum's reflectivity through the patches
Cleans the transfer roll
Calculates reflectivity ratios and operating points in order to attain each operating point's
darkness target
Modifies the EP mechanism as necessary to adjust toner darkness.
)
to return to the EVENT LOG menu.
).
).
).
).
or to view additional error codes. press to view