Installing Mig Wire Spool And Adjusting Hub Tension - Miller Millermatic 210 Owner's Manual

4-10. Installing MIG Wire Spool and Adjusting Hub Tension

Installing 1 Or 2 lb Wire Spool
Spindle
Remove these
components
from spindle.
Tools Needed:
OM-1325 Page 14
Use compression spring
with 8 in (200 mm) spools.
Spindle
Order extra spring
Part No. 186 437
15/16 in
Return To Table Of Contents
When a slight force is needed
to turn spool, tension is set.
To install either a 1 lb or 2 lb wire
spool, follow the procedure as
shown in the illustration.
Install these
components
onto spindle.
072573-B / 802 922