Installing Drive Roll And Wire Inlet Guide; Installing Wire Spool And Adjusting Hub Tension; Positioning Jumper Links; Electrical Service Guide - Miller INTEGRA 350 Professional Owner's Manual

2-5. Installing Drive Roll and Wire Inlet Guide

2-6. Installing Wire Spool and Adjusting Hub Tension

Tools Needed:
15/16 in

2-7. Positioning Jumper Links

2-8. Electrical Service Guide

Input Voltage
Input Amperes at Rated Output
Max Recommended Standard Fuse or Circuit Breaker Rating in Amperes
** Input Conductor Size in mm
** Grounding Conductor Size in mm
** Power cord supplied with the unit is sized for 230V operation. Larger power cord may be required for cable lengths greater than 3 meters. C
onsult national and local regulations.
5
2
3
4
1
When a slight force is needed to turn spool, tension is set.
230V
400V
2
2
1 Securing Screws
2 Inlet Wire Guide
Loosen screws. Slide tip as close to
drive rolls as possible without touch-
ing. Tighten screws.
3 Wire Tension Wheel
4 Drive Roll
Install correct drive rolls for wire size
and type.
5 Drive Roll Tension Assembly
Turn nut one click to secure drive
roll.
ST-150 227-C
ST-072573-B
Check input voltage available at
site.
1 Jumper Links Access
Remove side panel.
2 Jumper Link Label
Check label – only one is on unit.
3 Input Voltage Jumper Links
Move jumper links to match input
voltage.
Close and secure side panel.
230 400
32 19
32 19
6 6
6 6
OM-196 808 Page 7