Installing Wire Spool And Adjusting Hub Tension - Miller Millermatic 355 Owner's Manual

5-18. Installing Wire Spool And Adjusting Hub Tension

Installing 8 in. (203 mm) or 12 in. (304 mm) Wire Spool
Removing 8 in. (203 mm) or 12 in. (304 mm) Spool Hub And Spool Nut
1
Installing 4 in. (102 mm) Wire Spool
4
2
5
6
Hand tighten knob clockwise. When a slight
force is needed to turn spool, tension is set
1 Spindle
2 Spool Hub And Nut — For 8 in. (203 mm)
3 Spindle Hardware
Remove spindle hardware and retain. Re-
move spool hub and spool nut and retain for
future use.
3
4 Spindle
5 Washer, Flat
6 Spring, Compression
7 Spindle Hardware
Install Spindle hardware on spindle in exact
order as shown and tighten slightly.
7
or 12 in. (304 mm) Spool Only
Order two additional flat washers (Part
No. 605941).
Order one additional spring (Part No.
186437).
OM-288360 Page 31