Volt-Ampere Curves; Installing Work Clamp; Installing Welding Gun - Miller Millermatic 210 Owner's Manual

4-4. Volt-Ampere Curves

4-5. Installing Work Clamp

Tools Needed:
3/4 in

4-6. Installing Welding Gun

2 1
3
1
3
4
2
Return To Table Of Contents
Volt-ampere curves show minimum
and maximum voltage and amper-
age output capabilities of unit.
Curves of other settings fall be-
tween curves shown.
va_curve1 4/95 − 192 436
1 Work Cable
2 Boot
Route cable through front panel
opening. Slide boot onto work
cable.
3 Negative (−) Output Terminal
Connect cable to terminal and
cover connection with boot.
Close door.
Ref. 802 474-D
1 Drive Assembly
2 Gun Securing Knob
3 Gun End
Loosen securing knob. Insert gun
end through opening until it bottoms
against drive assembly (make sure
gun end does not touch drive rolls).
Tighten knob.
4 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
Close door.
Ref. 802 064-C
OM-1325 Page 11