Bypass Copying On Standard Size Paper - Toshiba e-studio 2550c Copying Manual

2 HOW TO MAKE COPIES
The operating procedure for bypass copying differs depending on the paper size to be used. See the table
below for the operating procedure of each size.
Paper size
Other than North
America: A3, A4, B4,
B5
Standard size
North America: LD, LT,
LG, ST-R
Other than the above
Envelope
Others (Non-standard sizes)
Bypass copying stops when the paper placed on the bypass tray runs out during copying, even if the
paper of the same size is in any of the drawers. Copying restarts when paper is supplied to the bypass
tray.
When bypass copying has been completed, the [FUNCTION CLEAR] button on the control panel
blinks. Press this button to switch bypass copying to normal copying using the drawers.
(Even if you do not press the [FUNCTION CLEAR] button, the bypass copying mode will be cleared
when the automatic function clear mode kicks in after a specified period of time.)

Bypass copying on standard size paper

Copying on A3, A4, B4 and B5 size paper (in equipment other than for North
America) / LD, LT, LG and ST-R size paper (in equipment for North America)
1
Place the original(s).
2
Move the paper holding lever toward the outside.
Place paper with its copy side down on the bypass
tray.
48 Bypass Copying
P.48 "Copying on A3, A4, B4 and B5 size paper (in equipment
other than for North America) / LD, LT, LG and ST-R size paper (in
equipment for North America)"
P.52 "Copying on other than the above standard sizes of paper"
P.54 "Copying on an envelope"
P.58 "Bypass copying on non-standard size paper"
Procedure
1
2