Bypass Copying - Toshiba e-studio 2550c Copying Manual

Bypass Copying

When you make copies on OHP film, sticker labels, envelopes, Thick 4 paper (only for e-STUDIO5055C
Series), or non-standard size paper, place the copy paper on the bypass tray. Bypass copying is also
recommended for copying on standard size paper which is not set in any of the drawers.
If you select the paper size, you can utilize various functions such as the automatic paper selection
(APS) or the automatic magnification selection (AMS). For details, see the following page:
P.216 "Copying Function Combination Matrix"
If you place the originals on the RADF for bypass copying and do not set the paper size, the originals
will be copied upside down. Be sure to set the paper size when you wish to do bypass copying.
Open the bypass tray for bypass copying.
If the paper is large, pull out the paper holder.
When placing or removing copy paper, move the paper holding lever
toward the outside. After this, move the paper holding lever back
toward the equipment.
If thick paper cannot be fed, printing takes a long time after feeding
or the quality is poor, turn over the paper and place it again as
shown in the figure or place fewer sheets.
2 HOW TO MAKE COPIES

Bypass Copying

47