Lexmark MS510 Service Manual page 98

Error code Description
959.30 Pensive library flagged an invalid argument(s)
959.31 Pensive library flagged an invalid device address
959.32 Failure to init physical interface
959.33 Unknown/unexpected Error
959.34 System Pensive Bus Busy Error
959.35 Transmission Error
959.36 Pensive command is invalid due to unlocked device
status
959.37 Pensive command is invalid due to locked device status
959.38 Incremental counter id(s) are invalid
959.39 Invalid NV address
959.40 Invalid Pensive command
960.xx RAM Memory Error—RAM soldered on the card is bad
961.xx RAM Memory Error—optional DRAM is bad
964.xx Download Emulation Cyclic Redundancy Check (CRC)
Error—checksum failure detected in the emulation
header or emulation file.
975.xx Network Error—unrecognizable network port
976.xx Network Error—unrecoverable software error in
network port
978.xx Network Error—bad checksum while programming
network port
979.xx Network Error—flash parts failed while programming
network port
980.xx Engine experiencing unreliable communication with
the specified device
981.xx Engine protocol violation detected by the specified
device
982.xx Communications error detected by the specified
device—device can be:
•
Engine, Duplex, Tray x, Env Feeder
•
Output Bin x (Note: Used for single bin devices)
•
Bins x to y (Note: Used for multiple bin devices)
983.xx Invalid command received by the specified device
984.xx Invalid command parameter received by the specified
device
Action
Replace the controller board. Go to
board removals" on page
Replace the controller board. Go to
board removals" on page
Replace the bad memory card.
1
Disable the Download Emulation.
2
Program the download emulation into the
firmware card again.
3
If the above steps do not resolve the problem,
then replace the firmware card and download
the emulation again.
Call the next level of support.
Call the next level of support.
Diagnostic information
98
4514-630, -635, -636, -638, -639, -649
"Controller
185.
"Controller
185.