Before You Begin - Razor E100 Series Owner's Manual

Electric scooter razor e100 series
Hide thumbs Also See for E100 Series:
Table of Contents

Advertisement

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the scooter was 95 percent assembled and packed at the factory, there should not be any problems, even if the
box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 10 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 4 for charging information).
Charger
(Note: Charger design may vary
from one shown)
LED lights for
E100 Glow only
Motor
- Battery
- Control Module
Required Tools
5 mm Allen wrenches
(Included)
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Twist Grip Throttle
Handlebar Stem
On/Off Switch
Charger Port
Reset Button
Brake Lever
Collar Clamp
Limiter
Front Fork
2
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC SCOOTER. The
scooter has been built to certain
Razor design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may not be compatible
and will void the warranty.
Note: Electric scooter must be
moving at 3 mph/5 kmh while
pressing the push button throttle
to engage motor.
Product ID Locations:
1. Handlebar Stem
2. Underneath battery tray
3. Charger
4. Box - side of UPC (not shown)
Plastic Bag Contents:
• Charger
• Tools
• Owner's Manual

Advertisement

Table of Contents
loading

Table of Contents