Initialization Of Data; Initializing All Page Data; Initializing Single Page Data - Sony DSC-F828 Service Manual

1-8.

INITIALIZATION OF DATA

1. Initializing All Page Data

By performing the following procedure, data of all pages will be
initialized.
Note: If all page data have been initialized, all adjustments need
to be performed again.
Initializing Method:
1) Select page: 00, address: 01 and set data: 01.
[Sector Write]
2) Click on the SEUS screen to display the SEUS
SECTOR WRITE screen.
3) Check that the SET ID is "03".
[All]
4) Click of the ALL SELECT buttons to select all pages.
(Fig. 6-1-78 A)
[Write]
5) Click to write the initializing data to the flash memory
of the camera.
6) Wait for 3 sec.
[Close]
7) Click to close the SEUS SECTOR WRITE screen.
8) Select page: 8E, address: 00 and set data: 20.
[Save]
9) Click on the SEUS screen.
10) Wait for more than 3 sec.
Processing after Completing Initializing
Order Page Address
1 20 00 29
2 20 01 29
Note: At this time, the camera is reset and the power is turns off
once and then on again. Accordingly, the message "Re-
ceive Packet Error" is displayed on the SEUS screen, and
the SEUS goes in "disconnect" state, but this is not a
[Connect]
trouble. Click
the "connected" state. (In case that the power does not turn
on again, press the power button.)
B
A
Fig. 6-1-78
DSC-F828
Data Procedure
[Set]
[Set]
(Note)
on the SEUS screen to restore
03

2. Initializing Single Page Data

By performing the following procedure, data of the page that you
want to initialize will be initialized.
Note 1: If the 6E or 6F page data have been initialized, the fol-
lowing adjustment needs to be performed again.
1) Camera system adjustments
Note 2: If the 8F page data have been initialized, the following
adjustment needs to be performed again.
1) Video system adjustments
2) LCD system adjustments
Initializing Method:
1) Select page: 00, address: 01 and set data: 01.
[Sector Write]
2) Click
SECTOR WRITE screen.
3) Check that the SET ID is "03".
4) Click "All" of the option buttons of target page. (Fig. 6-1-78
B)
[Write]
5) Click to write the initializing data to the flash memory
of the camera.
6) Wait for 3 sec.
[Close]
7) Click to close the SEUS SECTOR WRITE screen.
8) When 8E page is initialized, select page: 8E, address: 00 and
set data: 20.
[Save]
9) Click on the SEUS screen.
10) Wait for more than 3 sec.
Processing after Completing Initializing
Order Page Address
1 20 00
2 20 01
Note: At this time, the camera is reset and the power is turns off
once and then on again. Accordingly, the message "Re-
ceive Packet Error" is displayed on the SEUS screen, and
the SEUS goes in "disconnect" state, but this is not a
[Connect]
trouble. Click
the "connected" state. (In case that the power does not turn
on again, press the power button.)
6-30
on the SEUS screen to display the SEUS
Data Procedure
[Set]
29
[Set]
29 (Note)
on the SEUS screen to restore