5. Data Save Error
Symptom
data cannot be saved normally. (The data set-
ting during adjustment cannot be cancelled)
• Data writing to the flash memory failed.
Cause
• Connection is faulty.
• Power supply is not installed correctly.
• On the SEUS Operation screen,
Remedy
• Check the connection.
• Install the power supply correctly.
1-7-2.
Precautions When an Error Occurred
The Automatic Adjustment Program sets the data for adjustment
before the adjustment starts. Accordingly, if the adjustment termi-
nates by an error, the data during the adjustment may be left in the
camera.
Note 1: With this data left in the camera, the camera will not
operate normally.
[Release Data Setting]
In this case, the
"red" on the screen as shown in Fig. 6-1-74 to Fig. 6-1-77. Click
[Release Data Setting]
the
the data setting is cancelled, the button color becomes "white".
Note 2: When "Data Save Error" occurred, the
Setting]
To cancel the data setting, perform it on the SEUS Op-
eration screen. How to cancel the data setting is displayed
in the error message.
DSC-F828
Fig. 6-1-73
to the pages and addresses displayed in the
[Save]
message, and
them. (Cancel manu-
ally the data setting during adjustment.)
button is displayed in
button to cancel the data setting. When
button is displayed in "white".
Video System Adjustment screen
How to cancel the
data setting during
adjustment is
Camera System Adjustment screen
display here.
[Set]
the data
EVF System Adjustment screen
[Release Data
LCD System Adjustment screen
6-29
Fig. 6-1-74
Fig. 6-1-75
Fig. 6-1-76
Fig. 6-1-77