Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Sp Imp.); Selecting The Remote Control Id (Remote Id) - Yamaha RX-V671 Owner's Manual

Configuring the system settings
(ADVANCED SETUP menu)
You can configure the system settings of this unit using the front display.
1
Set this unit to standby mode.
2
While holding down STRAIGHT on the font panel, press MAIN ZONE
MAIN ZONE
PROGRAM STRAIGHT
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE to set this unit to standby mode and turn it on
again.
The new settings become effective.

ADVANCED SETUP menu items

Item Function
SP IMP. Changes the speaker impedance setting.
REMOTE ID Selects the remote control ID of the main unit.
(Asia and General models only)
TU
.
Changes the frequency step setting.
TV FORMAT Switches the video signal type.
MON.CHK Removes the limitation on HDMI video output.
INIT Restores the default settings.
UPDATE Updates the firmware.
Checks the version of firmware currently installed on
VERSION
this unit.

Changing the speaker impedance setting (SP IMP.)

SP IMP. -8 MIN
Change the speaker impedance settings of unit depending on the impedance of the
speakers connected.
Settings
Select this when you connect 6-ohm speakers to this unit. You can also
6 Ω MIN
use 4-ohm speakers as the front speakers.
8 Ω MIN (default)
Select this when you connect 8-ohm or higher speakers to this unit.

Selecting the remote control ID (REMOTE ID)

REMOTE ID -ID1
Select the remote control ID of the main unit so that it matches to the ID of the remote
control (default: ID1). When using multiple Yamaha AV receivers, you can set each
remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
Page
100
100
101
101
101
101
102
102
100
En