Fm/Am Radio; Usb And Network - Yamaha RX-V671 Owner's Manual

FM/AM radio

Problem
FM radio reception is weak or noisy.
AM radio reception is weak or noisy.
Radio stations cannot be selected
automatically.
AM radio stations cannot be registered
as presets.

USB and network

Problem
This unit does not detect the USB
device.
Folders and files in the USB device
cannot be viewed.
The network feature does not function.
This unit does not detect the PC.
Cause
There is multi-path interference.
Your area is too far from the FM station transmitter.
The noises may be caused by fluorescent lamps, motors,
thermostats, or other electrical equipment.
Your area is too far from the FM station transmitter.
The AM radio signal is weak.
"Auto Preset" has been used.
Cause
The USB cable connecting this unit and USB device is not
compliant with USB 2.0.
The folder structure not supported by this unit is applied.
The network parameters (IP address) is not obtained properly.
The media sharing setting is not correct.
Some security software installed on your PC is blocking the access
of this unit to your PC.
This unit and PC are not in the same network.
Remedy
Adjust the FM antenna height or orientation, or place it in a different location.
Press MODE to select monaural FM radio reception (p.47).
Use an outdoor FM antenna commercially available. We recommend using a
sensitive multi-element antenna.
It is difficult to completely eliminate noise. It may be reduced by using an outdoor
AM antenna commercially available.
Select the station manually (p.47).
Use an outdoor antenna commercially available. We recommend using a
sensitive multi-element antenna.
Adjust the AM antenna orientation.
Select the station manually (p.47).
Use an outdoor AM antenna commercially available. Connect it to the ANTENNA
(AM/GND) jack together with the supplied AM antenna.
"Auto Preset" is for registering FM radio stations only. Register AM radio stations
manually (p.48).
Remedy
Use a USB cable compliant with USB 2.0.
This unit supports folder hierarchies of up to 8 levels and up to 500 items (total of
files and subfolders) per folder. If necessary, modify the folder structure on your
USB device.
Enable the DHCP server function on your router and set "DHCP" in the "Setup"
menu to "On" on this unit (p.94). If you want to configure the network parameters
manually, make sure using an IP address which is not used by other network
devices in your network (p.94).
Configure the sharing setting and select this unit as a device to which music
contents are shared (p.62).
Check the settings of security software installed on your PC.
Check the network connections and the settings of your router to connect them to
the same network.
111
En