Test Print Mode - SATO HR2 Series Operator's Manual

Section 3: Operation and Configuration

3.13 TEST PRINT MODE

When the above TEST PRINT
was set as CONFIGURATION,
BARCODE, HEAD CHECK or
HEAD SENSOR
+
-
FEED button
The Test Print Mode offers nine different printer status labels for troubleshooting.
1. Make sure the Power of the printer is turned off (O).
2. While pressing the FEED button, switch the Power to On (I).
3. TEST PRINT MODE is displayed on the screen. Press the FEED button repeatedly will switch to the next
setting options as shown above. To return to the previous setting option, press LINE button.
4. When the desired setting option is displayed, press +, - or < > arrow buttons to select the item or to set the
value and then press FEED button to save the setting.
Page 3-36
Press FEED button
+ Switch Power to On " I "
FEED button
FEED button
LINE button
When the above
TEST PRINT was
set as FACTORY1/2
FEED button
FEED
button
LINE button
+
-
FEED button
Test print
* Press <, >, + or - button to select
When the above
TEST PRINT was set
as SMALL PITCH
+
-
FEED button
or
button
+
-
FEED button
item or set the value accordingly.
The active icons are displayed on
the screen.
When the
above
TEST
PRINT was
set as
FONT or
MEMORY
or
button
FEED button
HR2 Series Operator Manual
Displayed
only when
SMALL
PITCH and
TEAR OFF
+
-
are selected