Error Messages; Printer Panel Message - Kyocera FS-5900C User Manual

Error Messages

Add paper ( paper source)
(paper size)(media type)
Battery error
Call service
person##:#######
Cassette 1
not loaded
Cassette 2
not loaded
Cassette 3
not loaded
Duplex unit
not loaded
Format error
Front/Right
cover Open
HARDDISK error##
Press CONTINUE
1 The total printed pages is not shown when the error code is F0 (Communication error).
Care and Maintenance

Printer Panel Message

Error Message
MEMORY CARD
(Media)
Possible Cause
The paper source is out of
paper.
The memory card's
battery is run out or not
installed.
A failure requiring the
attention of service
personnel has occurred.
The printer's media
cassette is not loaded in
the printer, or not closed
fully in position.
The paper feeder's top
media cassette is not
loaded in the paper
feeder, or not closed fully
in position.
The paper feeder's bottom
media cassette is not
loaded in the paper
feeder, or not closed fully
in position.
The Duplex unit is not
installed in the printer.
The hard disk or memory
card is not formatted.
The front or right side
cover is open.
The printer has encoun-
tered an error during
access to the optional
hard disk.
Corrective Action
Add paper to the paper cas-
sette or multi-purpose tray.
Not only the paper source, but
also the paper size and media
type set for the paper source in
question are displayed.
Insert a new battery in the
memory card. (See the memory
card manufacturer's instruc-
tion.)
Note the corresponding error
code (## followed by the colon)
and the total printed pages
(####### preceded by the
colon). Turn printer power off
and call for service.
Insert the media tray, or close it
securely. (Cassette 1 is shown
as Cassette when no option
paper feeder is installed.)
Insert the top media tray, or
close it securely. (This mes-
sage is shown only when the
printer is installed with an
option paper feeder.)
Insert the bottom media tray,
or close it securely. (This
message is shown only when
the printer is installed with an
option paper feeder.)
Install the Duplex unit in the
printer.
Format the media (For a
memory card, P. 60).
Check both covers and close
them tightly.
Note the error code (##)
preceded by the HARDDISK
error message. Then, press
CONTINUE to clear the error
situation. Refer to section
Hard disk Error Codes
( P. 99).
1
93