Kyocera Ecosys FS-3820N Operation Manual page 95

6
Press the > key. Each time the
changes as shown below.
>NetWare
On
>TCP/IP
On
>EtherTalk
Off
>Network Status
Page On
7
The following example explains how to activate TCP/IP protocol to
connect the printer in the network. You can select Netware or
EtherTalk in a similar manner.
>TCP/IP
On
If TCP/IP is currently Off is displayed, select On using the
key. Press the ENTER key again.
>TCP/IP
? On
or
Range
Set this item to On when you connect to a
>
network using NetWare. In submenu (>),
frame mode can be selected from Auto,
Ethernet, 802.2, 802.3, and 802.3 SNAP .
Set this item to On when you connect to a
>
network using TCP/IP . Submenu (>) has
items including DHCP , IP address, subnet
mask address, and gateway address.
EtherTalk must be activated (On) for
networking with Macintosh computers.
When the item is set to On, the printer prints
out a network status page when it prints the
printer status. See page
>
1-79
key is pressed, the display
.
1-19
>TCP/IP
On
Interface
or
>