Network Interface Card - Kyocera FS-1010 Operation Manual

A.4 Network Interface Card
If the serial interface board kit is installed, remove it to use the network
interface card.
Insert the option network interface card into the option interface slot at the
rear of the printer. The network interface card enables the printer to be
used in a network.
1
Turn off the printer and disconnect the power cord and printer cable.
2
Remove the two screws from the option interface slot cover and
remove the slot cover.
Screws
3
Insert the network interface card and secure it with the screws
removed in step 2.
Screws
A-10
Option Interface Slot Cover

Network Interface Card

Network Interface Card