11. Test The Printer - Kyocera DP-3600 Instruction Handbook Manual

Chapter 1 Safeguards and Installing the Page Printer

11. Test the printer.

1- 28
Use the following procedure to test the printer and print out a status page indicating factory settings.
For details on the indicators and keys on the printer's control panel, please refer to Chapter 2
Control Panel.
1. Turn on the printer's power switch.
It does not matter whether the computer's power is on or off. Self test will be displayed in
the message display of the printer.
Notes_____________________________________________________________________
·
When the printer's power is turned on after a toner container has been installed for the first time,
the printer will display the message Please wait for about five minutes until it becomes ready
for printing (Ready). Note that the printer is not broken.
·
An error message of the form XXX Open will be displayed in the printer's message display
unless all covers on the printer are properly closed. If this happens, check that the part indicated in
the error message is properly closed.
2. Wait until the ON LINE indicator lights and Ready appears in the message display.
If the ON LINE indicator is off, make it light by pressing the ON LINE key.
3. Press the STATUS key. Information such as the memory allocation currently set for the printer
will be printed on a page in a list.
If the status page prints without problems, you can tell that the developer unit and paper feed cassette
are installed properly. For details on the contents of the status page, see Chapter 2.