Test The Printer - Kyocera FS-600 Installation Manual

Hide thumbs Also See for FS-600:

Table of Contents

Test the printer

Use the following procedure to test the printer and print out a status page indicating factory settings. For

details on the indicators and keys on the printer's control panel, please refer to Chapter 2 The Control

Panel in the User's Manual on CD-ROM.

Turn on the printer's power switch.

It does not matter whether the computer's power is on or off. The six indicators flash in sequence.

Note______________________________________________________________________

Jam indicator flashes unless all covers on the printer are properly closed. If this happens, check that the

part indicated in the error message is properly closed. (See Appendix D in the User's Manual on

CD-ROM.)

Wait until the ON LINE/A4 indicator lights.

If the ON LINE/A4 indicator is off, make it light by pressing the ON LINE/STATUS key.

Press the SHIFT and ON LINE/STATUS keys. Information such as the memory allocation, etc.,

currently set for the printer will be printed on a page in a list.

If the status page prints without problems, you can tell that the developer unit and paper feed cassette

are installed properly.

Table of Contents