Set the computer to the same parameters as the printer. On many computers
8.
by setting DIP switches before power is turned on. Another method is as follows:
In DOS, enter the following commands:
C>MODE COM1:96,N,8,1,P
C>MODE LPT1:=COM1
To test the interface, then enter:
CTRL P
C>DIR
CTRL P
The software settings made by the procedures above are temporary. On most computers,
permanent settings must be made with DIP switches.
If you want to use a different baud rate or change any of the other RS-232C parameters, you can
use the printer's FRPO (firmware reprogram) command. See the Programming Manual for
details.
RS-232C Cable Connection
this can be done
C-19