Table of Contents
Advertisement
Hot Key
When this option is selected, select the function key
you would like to use to power-on the system in
the "Hot Key Power On" field.
Mouse Left
When this option is selected, double-click the left
button of the mouse to power-on the system.
Mouse Right When this option is selected, double-click the right
button of the mouse to power-on the system.
Any Key
Press any key to power-on the system.
Keyboard 98 When this option is selected, press the "wake up"
key of the Windows
power-on the system.
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password has
been set in this field. You must type the correct password to power-
on the system. If you forgot the password, power-off the system and
remove the battery. Wait for a few seconds and install it back
before powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use
to power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3 Allows you to manu-
ally select an I/O address for the onboard serial port 1
and serial port 2.
Disabled Disables the onboard serial port 1 and/or serial port 2.
BIOS Setup
®
98 compatible keyboard to
3
8 3
Advertisement
Table of Contents
