Table of Contents
Advertisement
4
Supported Software
RAID Configuration and 6300ESB RAID Drivers
The following describes the steps on configuring RAID.
1. Set the "On-Chip Serial ATA" field to "Enhanced Mode". (Inte-
grated Peripherals submenu - OnChip IDE Device" section of the
Award BIOS.)
2. Set the "SATA Mode" field to "RAID". (Integrated Peripherals
submenu - OnChip IDE Device" section of the Award BIOS.)
3. Reboot the PC.
4. When the system powers-up, press the <Ctrl> and <I> keys
simultaneously to run the Intel RAID BIOS Setting Utility. The
utility is used to configure the Serial ATA drives to RAID 0 or
RAID 1.
5. Install the Intel 6300ESB RAID driver.
If you are in the process of installing Windows
Windows
need the provided Intel RAID floppy diskette. If you are installing
the driver on existing Windows
the "Intel 6300ESB RAID Drivers" that is in the provided CD.
Installing the RAID Driver While Installing Windows
2000
The steps below will instruct you on installing the 6300ESB RAID
driver while in the process of installing Windows
2000 on a RAID 0 or RAID 1 Volume Serial ATA drives.
1. Start Windows Setup by booting from the installation CD.
2. Press <F6> when prompted at the beginning of Windows setup.
3. Press <S> to select "Specify Additional Device".
4. At this point you should be prompted to insert a floppy disk
containing the Intel 6300ESB RAID driver. Insert the provided
floppy diskette.
112
®
2000 on RAID configured Serial ATA drives, you will
®
®
XP or Windows
®
XP or Windows
®
XP or Windows
®
XP or
2000, install
®
®
Advertisement
Table of Contents
