Table of Contents
Advertisement
5. Select "Intel
press <Enter>.
6. The next screen should confirm that you have selected the
Intel(r) RAID controller. Press <Enter> again to continue.
7. Finish the Windows installation. Leave the floppy disk in the
floppy drive until the system reboots itself. Windows setup will
need to copy the files from the floppy disk again after the RAID
volume is formatted, then Windows setup starts copying files.
Installing the RAID Driver Under Existing Windows
2000
To install:
1. Click "Intel 6300ESB RAID Drivers" on the main menu. The
following screen will appear.
2. Follow the installation instructions shown on the screen.
3. Reboot the system for the driver to take effect.
®
6300ESB SATA RAID Controller" from the list then
Supported Software
®
XP or Windows
4
®
113
Advertisement
Table of Contents
