Table of Contents
Advertisement
2
Hardware Installation
Chassis Open Connector
The system board supports the chassis intrusion detection func-
tion. To use this function, connect the chassis intrusion sensor
cable from the chassis to J6. Whenever a chassis component has
been removed, the sensor sends signal to J6 alerting you of a
chassis intrusion event. To disable this function, refer to the "Intrusion
Event" section on page 95 of the manual.
56
Chassis signal
2
Ground
1
Note:
The Hardware Doctor utility does not support the chassis
intrustion detection function. This function must be configured in
the BIOS. Refer to page 95 for more information.
Advertisement
Table of Contents
