Displaying Igmp Filtering Configuration - Cisco Catalyst 2950 Software Configuration Manual

Displaying IGMP Filtering Configuration

Displaying IGMP Filtering Configuration
You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the switch or for a specified interface.
Beginning in privileged EXEC mode, use the commands in
configuration:
Table 16-8 Commands for Displaying IGMP Filtering Configuration
show ip igmp profile [profile
number]
show running-configuration
[interface interface-id]
This is an example of output from the show ip igmp profile privileged EXEC command when no profile
number is entered. All profiles defined on the switch appear.
Switch# show ip igmp profile
IGMP Profile 3
IGMP Profile 4
This is an example of the output from the show running-config privileged EXEC command when an
interface is specified with IGMP maximum groups configured and IGMP profile 4 has been applied to
the interface.
Switch# show running-config interface fastethernet0/12
Building configuration...
Current configuration : 123 bytes
!
interface FastEthernet0/12
no ip address
shutdown
snmp trap link-status
ip igmp max-groups 25
ip igmp filter 4
end
Catalyst 2950 Desktop Switch Software Configuration Guide
16-22
Displays the specified IGMP profile or all IGMP profiles defined on the switch.
Displays the configuration of the specified interface or all interfaces on the switch,
including (if configured) the maximum number of IGMP groups to which an interface can
belong and the IGMP profile applied to the interface.
range 230.9.9.0 230.9.9.0
permit
range 229.9.9.0 229.255.255.255
Chapter 16 Configuring IGMP Snooping and MVR
Table 16-8 to display IGMP filtering
78-11380-04