Assign Member Node - Toshiba IPedge Installation Manual

ASSIGN MEMBER NODE

ASSIGN MEMBER NODE
4-18
The previous procedure sets up each IPedge server as a stand alone
system. The following procedure changes a server to a member server
and attaches that server to the Primary Node.
This procedure is performed for each member server in an enterprise.
Important! Member nodes must be attached one-at-a-time.
Complete this procedure for one node. Then, complete
this procedure for the next node.
1. Login to Enterprise Manager on the IPedge server that you want to be
a member of an enterprise. Use the IP address of the server to
access Enterprise Manager on that node.
2. Select Administration > Enterprise > Server Management.
3. Click on the Member Server radio button.
4. Enter the Primary Server IP address.
5. Enter the Community Name you assigned to this member server
earlier.
6. Click on the Save icon.
7. The server will stop accepting commands.
MEETING IP Address Change Procedure
Installation Manual June, 2011