Toshiba IPedge Installation Manual page 131

AUDIOCODES MP118 FXS
Installation Manual June, 2011
9. Select Protocol Configuration > Sip Advanced Parameters
>advanced Parameters.
Set the Disconnect on broken connection = No
Set Enable current disconnect = Enabled.
10. Click on the Submit button.
11. Select Protocol Configuration > Routing Tables > Routing
General Parameters.
Enable alternate routing = Enabled
12. Click on the Submit button.
13. Select Protocol Configuration > Routing Tables >Tel To Ip
Routing. This is the routing from the analog device to the SIP station
in the IPedge system.
Src Trunk Group = *
Dest Phone Prefix = *
Source phone Prefix = *
Dest IP Address = IP address of the IPedge server
14. Select Protocol Configuration > Routing Tables > Ip To Trunk
Group Routing. This is IPedge SIP station to analog device routing.
Note: If this gateway was setup as an FXO gateway there will be entries
on line 1. The Prefixes and Source IP Address will all be set to *.
This line of entries must be moved down. the FXS entries with
DNs entered for the Dest. Phone Prefixe must be at the top of the
table.
For each analog station connected to the gateway enter:
Dest Host Prefix = *
Source Host Prefix = *
Dest Phone Prefix = Analog station DN
Source phone Prefix = *
Source IP address = *
Hunt Group = 2
IP Profile ID = 0
Source IP Group ID = -1
15. Click on the Submit Button.
16. Select Protocol Configuration > Endpoint Settings
>authentication.
For Port 1 FXS: Enter the DN of the first analog station.
Username: Enter the analog station DN
Password: Enter the analog station DN
Repeat this for each analog station. Each additional station is
programmed on the next port.
17. Click on the Submit button.
18. Select Protocol Configuration > Endpoint Number > Endpoint
Phone Number.
Channel = 1 (matches FXS Port number)
Phone number = Analog station DN(This number must be assigned in
the URI table of the IPedge server)
Hunt Group ID = 2
Tel Profile ID = 0
FXS Setup
12-11