Connection Plan - Studer XP-COMPACT-XPC 1400-12 User's And Installer's Manual

STUDER Innotec
− All cables must be tightly screwed in place. For safety, a yearly control is
recommended. In mobile installations control must be carried out more often.
− Connecting must be done by qualified personnel. Material such as cable,
connectors and distribution boxes, fuses etc. used in the installation must
comply with the respective valid low-voltage installation rules and regulations.
−
3.3.2 Protection
connections
The protection is available as an option (Order ref.
CFC-01) and avoid to do wrong hazardous
connection on the terminals 230Vac. It mounted
with strain relief clamps for the cable.
3.4

Connection Plan

M A
Don't open before
disconnect line
and battery
BATTERY
SOLAR
Remote
control
B
C
A Battery +/-
B SOLAR +/-
C Remote contr.
D Transfer delay
E Equalize
F Temp.
G Aux. Contact
H AC Input
cover of the
L
Caution:
Check battery
polarity (+/-) before connecting!
A wrong connection could
damage the system.
.
Auxiliary Contact
16A-250Vac
Temp.
F G
E D
Battery cable (already installed)
Connection terminal for Solar modules
Connection terminal for Remote Control RCC-01
Slide switch for delayed opening of transfer swich
Slide switch for equalization of the Battery
Connection terminal for Temperature sensor CT-35
Connection terminal for Auxiliary Contact
Connection terminal for AC-input. Located directly
above this terminal is the automatic safety cut-out for
this terminal.
XP-COMPACT V5.7
terminals
N
AC Input
H
XP-COMPACT
J
AC Output
K
11/79