Performing Cutting With Automatic Crop-Mark Detection - Roland SOLJET PROIII XC-540 User Manual

Performing Cutting with Automatic Crop-mark Detection

When you make the setting for detecting crop marks when sending cutting data from the computer,
alignment is performed with the presence or absence of crop marks determined automatically. For in-
formation on how to make the settings, refer to the documentation for the software RIP you're using.
When the media has been removed, follow the steps below to reload it.
Procedure


Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the figure appears and operation
stops.
CROPMARK ERROR
NOT FOUND
If this happens, press

Reload the media, then send the data again.

If this does not resolve the problem, then perform alignment manually.
 P.56, "Aligning Manually and Cutting"
Crop mark
Blade protection
, then take action as follows.
3-3 Cutting Using the Crop-mark Feature
Load the media.
Angle by no more
5 degrees
than 5 degrees.
Otherwise alignment
5 degrees
becomes impossible.
Chapter 3 Using the Cutting Feature
55