Performing Cutting With Automatic Crop-Mark Detection - Roland XC-540 User Manual

Performing Cutting with Automatic Crop-mark Detection

When you make the setting for detecting crop marks when sending cutting data from the computer, alignment is
performed with the presence or absence of crop marks determined automatically. For information on how to make the
settings, refer to the documentation for the software RIP you're using.
When the media has been removed, follow the steps below to reload it.
Procedure
–
—
Send the cutting data.
Alignment is performed automatically, then cutting starts.
If Automatic Alignment Cannot Be Performed
If the machine fails to detect the crop marks, the screen shown in the figure appears and operation stops.
CROPMARK ERROR
NOT FOUND
If this happens, press
–
Reload the media, then send the data again.
—
If this does not resolve the problem, then perform alignment manually.
P.52 "Aligning Manually and Cutting"
If the crop marks cannot be detected easily because of the effects of media warping or the like, then perform alignment
manually.
When you want to perform automatic alignment with lengthy media, we recommend performing output with the data
separated into sizes that are as short as possible. With large sizes, error due to warping and the like increases, making
smooth detection impossible.
Crop mark
Blade protection
5 degrees
5 degrees
key, then take action as follows.
3-3 Cutting Using the Crop-mark Feature
Load the media.
Angled no more than 5 degrees.
Otherwise alignment becomes impos-
sible.
Chapter 3 Using the Cutting Feature 51