If An Error Message Appears - Roland SOLJET PROIII XC-540 User Manual

7-8 If an Error Message Appears

This describes the error messages that may
appear on the machine's display, and how
to take action to remedy the problem. If the
action described here does not correct the
problem, or if an error message not described
here appears, contact your authorized Roland
DG Corp. dealer.
[ALIGN POINT POSITION INVALID]
An attempt was made to set an align point
at a location where the setting cannot be
made.
No align point can be set when the angle of the base
point and the align point is too large.
Reload the media correctly, so that the angle is
minimized, then set the base point and the align point
again to match the crop marks.
 P. 55, "Performing Cutting with Automatic Crop-mark
Detection"
[OPTION-DRYER IS NOT CONNECTED]
When the drying-heater unit is not connected to the
printer, [OPTION DRYER] is set to "ENABLE." Switch the
sub power and main power off, and then connect the
drying-heater unit to the printer.
[HEATING TIMEOUT CONTINUE?]
The media heating system did not reach the
preset temperature.
This occurs because the temperature of the location
where the machine is installed is too low. We recom-
mend raising the temperature. To quit printing, hold
down for one second or longer. To continue
waiting for the temperature to rise, press
start printing immediately, press
[CARRIAGES ARE SEPARATED]
The cutting carriage and the printing carriage
were improperly disconnected.
A problem such as a media jam occurred, impeding
correct operation. Operation cannot be continued.
Switch the sub power off, then back on.
154
Chapter 6 Feature Reference
[CAN'T PRINT CROP CONTINUE?]
The size of the data including the crop marks
is larger than the printing or cutting area of
the loaded media.
To continue performing output without correcting
this, press
ing beyond the printing or cutting area and the crop
marks are not printed. To stop output, stop sending
data from the computer, then raise the loading lever.
Make the printing or cutting area wider, such as by
replacing the media with a larger piece of media or
by changing the positions of the pinch rollers, then
send the data again.
The size of the data being output is too small.
Make the scanning-direction size of the data at least
65 mm (2-9/16 in).
To continue performing output without correcting
this, press
without printing the crop marks. To stop output, stop
sending data from the computer, then hold down
for one second or longer. Change the size
of the data, then send the data again. There is no
limitation in the size of the data in the media-feed
direction.
[CROPMARK ERROR NOT FOUND]
Automatic detection of crop marks could not
be accomplished.
Load the media at the correct position and perform
detection of crop marks again. Depending on the
media, it may not be possible to detect crop marks
automatically. If repeating automatic crop-mark de-
tection results in an error again, then perform manual
crop-mark detection.
. To
 P. 56, "Aligning Manually and Cutting"
.
[TEMPERATURE IS TOO HIGH **°C]
The temperature of the location where the
machine is installed has risen above the
ambient temperature at which the machine
can operate.
Operation cannot be continued. Switch off the sub
power. The displayed temperature is the current ambi-
. At this time, the portion extend-
. At this time, the data is output