Table of Contents
Advertisement
14. Plug the Reed Switch (61) into the Transmitter
(63).
Insert the other end of the Reed Switch (61)
into the Clamp (67).
Rotate the Flywheel (36) until the Magnet (66)
is aligned with the end of the Reed Switch (61).
Move the Reed Switch (61) so that the gap
between the Reed Switch and the Magnet (66)
is about 1/8 in. (3 mm).
15. Make sure that all parts are properly tightened before you use the exercise bike. Note: After assembly
is completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
If you purchase the optional chest pulse sensor (see page 18), follow the step below to install the
receiver included with the chest pulse sensor.
16. See step 11 on page 9 and remove the Console
(68) from the Console Bracket (64).
Remove the three screws from the back cover
(A) of the Console (68), and then remove the
back cover.
Connect the wire on the receiver (B) to the wire
in the Console (68). Hold the receiver so that
the antenna is oriented as shown and is fac-
ing upward.
Remove the paper from the adhesive pad on
the back of the receiver (B). Press the receiver
onto the console in the indicated location. Then,
reattach the back cover (A).
Reattach the Console (68) to the Console
Bracket (64).
Note: Discard any other wires that are included
with the chest pulse sensor.
14
61
16
A
68
11
67
36
66
63
B
Antenna
Wires
Attach
receiver
here
Advertisement
Table of Contents
