Installation Hardware 'Eprom Programmer; General; Installation Adapter Card - IPSO -LSG MICRO 9 User Manual

Installation hardware 'eprom programmer'

General

Installation of the adapter card
The computer has to be disconnected during the execution of
the following acts. Ignoring this instruction can lead to physical
injury (electrocution) ; damage of the SAC 201 card or damage
of the eprom programmer.
The SAC 201 adapter card as well as the 'eprom programmer' have to be
installed in order to program the desired wash programs on the eproms.
❺
Disconnect the computer, pull the plug out of the plug switch .
❺ Remove the cover of the computer .
❺ Check the position of the DIP-switches on the adapter card :
SW1: all switches 'OFF'
SW2: switch 7 'ON'
other switches 'OFF'
SW3: switch 2 'ON'
other switches 'OFF'
❺
Put the SAC 201 card carefully in the computer. Use the supplied screw to
lock it.
1
6