Table of Contents
Advertisement
Example:
T1: 5
T2 : 3
T3: 10
First during 5 seconds, water will be taken through the programmed inlets.
Then during 3 seconds, no water will be added.
If the temperature is still lower than the programmed temperature, warm water will be added during 10
seconds.
If the temperature would be higher already, cold water will be added during 10 seconds.
Afterwards, again 3 seconds of mix and then again ten seconds of warm or cold water will be added etc...
Should "0" be filled in for T2, then after filling time T1, cold or warm water will be added if necessary
continuously without stopping.
26
Advertisement
Table of Contents
