press
press
type
E
press
press
press
press
type
Y
to go to 'I/O select'
the list of addresses appears on the display
which corresponds with '2EO'
to confirm
❺
When the following message appears on the display:
'error identification on hardware'
This means that in the computer a card has been put with the same I/O
address as the SAC 201 card.
Act as follows:
to go to 'Quit' of the menu bar
to confirm
to leave the program
❺
Disconnect the computer, pull the plug out of the plug switch.
❺
Remove the cover of the computer.
❺
Remove the SAC 201 card from the computer.
❺
Change the position of the DIP-switches:
SW1: select one switch 'ON'
other switches 'OFF'
SW2: switch 7 'OFF'
select one switch 'ON' when SW1 is completely 'OFF'
others 'OFF'
SW3: switch 2 ALWAYS 'ON'
2
12