Installation Of Indoor Unit; Installation De L'unite Interieure; Installation Der Raumeinheit; Installazione Dell'unità Interna - Toshiba RAS-M10GDCV-E Installation Manual

4 INSTALLATION OF INDOOR UNIT

WARNING
Install the air conditioner certainly at a place to sufficiently withstand the weight. If the strength is insufficient, the unit may fall
down resulting in human injury.
Perform a specified installation work to guard against an earthquake.
An incomplete installation can cause accidents by the units falling and dropping.
Return air method is choiced from rear or under direction as shown in figure.
• If a system to suck in air directly from the bottom of the unit is adopted, the noise level increases. It is recommended to mount the
return duct so that air is not directly sucked in.
Installation procedure
1. Lay drain pipes, refrigerant pipes, and connecting cables under wall or ceiling
concurrently with supply/drain water work and piping work.
2. Install the mounting frames of supply/return air panels
3. Position the refrigerant and drain pipes
4. Install the indoor unit
• Preparation for installation
• Setting/fixing of indoor unit
5. Connect cables and pipes
6. Mount the switch panel and set switches
7. Install supply/return air panels
8. Mount thermal insulation
9. Mount check port
NOTE
For installation of the outdoor unit, refer to the Installation manual (Packed in the outdoor unit).
Return air from rear side Return air from bottom side
5 EN