Table of Contents
Advertisement
4358-5356 US All in One
7/26/10
4
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it, can result in
serious injury or death.
5
34
4:16 PM
Page 37
With weakest hand at belt
path, tilt and push the
child restraint forward
and back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be
secure.
NOTE:
Some "play" from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review "Knowing
Your Vehicle Belts" and
"The Locking Clip"
sections.
After checking for hot seat
and buckles, place your
child in the child restraint
as described in the
"Securing Your Child in the
Child Restraint" section.
Forward-Facing Installation with
LATCH Belt: Install LATCH Belts
NOTE:
1
LATCH system along
with the adult lap or
lap/shoulder belt.
Route LATCH belt
through upper slot in
side of shell.
Pull one LATCH hook
2
across the back and out
the other side.
The LATCH adjuster
can be on either side,
but the belt should not
be twisted.
Place child restraint flush
3
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle
seat back, if needed.
Fasten one LATCH belt
4
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner's manual for
locations and more
information.
35
Do not use
continued on next page.
Advertisement
Table of Contents
