Connecting A Computer; Connecting Headphones; Connecting A Digital Sound System - Insignia NS-46E570A11 User Manual

Connecting a computer

To connect a computer:
1 Make sure that your TV's power cord is
unplugged and the computer is turned off.
2 Connect a VGA cable (not included) to the PC IN
jack on the back of your TV and to the VGA jack
on the computer.
Back of TV
3 Connect an audio cable to the
PC/DVI AUDIO IN jack on the back of your TV
and to the AUDIO OUT jack on the computer.
4 Turn on your TV, then turn on the computer.
5 Press INPUT to open the Source List.
6 Press or to highlight VGA, then press
OK/ENTER.
Note
When the computer enters Standby mode, your TV
turns off. If your TV does not turn on when you
"wake" your computer, press
or remote control.
For HDMI-DVI input from PC, the TV will enter
Standby mode after one minute if no signal is
detected.
12
NS-42E570A11/NS-46E570A11 Insignia 42"/46" LED-LCD TV, 120Hz 1080p

Connecting headphones

Connecting a digital sound system

(power) on your TV
www.insigniaproducts.com
The TV speakers are muted when headphones are
attached.
Warning
Loud noise can damage your hearing. When using
headphones, use the lowest volume setting on your
headphones that still lets you hear the sound.
To connect headphones:
• Connect headphones to the
your TV.
Side of TV
To connect a digital sound system:
• Connect a digital audio cable to the SPDIF jack on
the side of your TV and to the digital audio jack on
the amplifier.
Side of TV
on the side of
Digital sound system