Gps Message Automatic Transmission - Icom IC-92A Instruction Manual

8
GPS/GPS-A OPERATION (Optional UT-121 is required for IC-92A)
D GPS message automatic transmission
q Enter "GPS AUTO TX" in DV set mode.
➪
❮MENU screen❯
(Push [MENU/ ]) (Rotate [DIAL]
• GPS AUTO TX screen is displayed.
GPS AUTO TX
OFF OFF
r
5SEC 5SEC
10SEC 10SEC
30SEC 30SEC
1MIN 1MIN
w Rotate [DIAL]
†
to select the desired position data trans-
mitting interval from 5 sec., 10 sec., 30 sec., 1 min., 3
min., 5 min., 10 min., 30 min. and OFF.
• The position data is transmitted only when [PTT] is pushed with
OFF setting, the data is transmitted automatically once every
5 sec., 10 sec., 30 sec., 1 min., 3 min., 5 min., 10 min. and 30
min. when the appropriate setting is selected.
• The GPS message is also transmitted if programmed.
e Push [ ](5)
(or [ ](4))
r Push [MENU/
NOTE: Your own call sign ("MY") should be set to activate
the GPS automatic transmission.
[NOTICE]
"5SEC" cannot select when 4 GPS sentences are selected.
60
(p. 95)
➪
❮DV SET MODE❯ ❮GPS AUTO TX❯
†
, then push [ ](5)
to return to DV SET MODE screen.
] to return to frequency indication.
[NOTICE]
USE GPS message automatic transmission at simplex mode.
Sending with GPS message automatic transmission through the
repeater may interfere with other amateur radio.
†
.)
D Received GPS message indication
q Enter "RX GPS" in message/position set mode.
❮MENU screen❯
(Push [MENU/
• RX GPS MESSAGE screen is displayed.
w Push [ ](5)
screen.
e Push [MENU/
➪
❮MESSAGE/POSITION❯
†
]) (Rotate [DIAL] , then push [
RX GPS MESSAGE
DATA: DATA:
r
Call from Call from
Osaka! Osaka!
:BACK :BACK
to return to MESSAGE/POSITION
(or [ ](4))
] to return to frequency indication.
➪
❮RX GPS❯
†
](5) .)