Replacing The Status-Light Board; Procedure; Post-Requisites - Dell Alienware 17 R2 Service Manual

Replacing the status-light
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your
computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.

Procedure

1 Align the screw holes on the status-light board with the screw holes on
the palm-rest assembly.
2 Replace the screws that secure the status-light board to the palm-rest
assembly.
3 Slide the status-light board cable into the connector on the status-light
board and press down the latch to secure the cable.

Post-requisites

1 Follow the procedure from step 5 to step 11 in "Replacing the
2 Replace the base panel.
Computer. After working inside your
After Working Inside Your
palm rest".
47