Specifications; Standard Accessories; Operation - Ryobi EAG85125RG Owner's Operating Manual

Please read the instructions carefully before
starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.

SPECIFICATIONS

Grinding wheel diameter
Voltage
Input
Spindle thread
Rated speed
Disc bore size
Net weight
NOTE: Be sure to check the nameplate on the product,
because the voltage is subject to change depending on
the area in which the product is to be used.

STANDARD ACCESSORIES

See fi gure 1 and 3.
 Auxiliary handle
 Wrench
 Grinding wheel
 Sanding paper
 Sanding pad
APPLICATIONS
Use only for the purposes listed below:
 Grinding: metals
 Sanding: metals

OPERATION

The tool should never be connected to the power supply
when assembling parts, making adjustments, cleaning,
performing maintenance, or when the tool is not in use.
Disconnecting the tool will prevent accidental starting
that could cause serious injury.
125 mm (5 in)
240 V 50 Hz
850 W
M14 x 2
5,000 - 11,000 min
22.2 mm
2.8 kg
WARNING
MAIN HANDLE
See fi gure 4.
The main handle can be set to right and left at any of the
three positions (0 and 90 degrees) by pressing the rotary
lock button.
THREE-POSITION AUXILIARY HANDLE
See fi gure 2.
Specifi cally designed and angled to three-position for
maximum comfort and control.
SWITCH
See fi gure 1.
 To turn the tool on, press the lock button and then pull
the switch trigger.
 To turn the tool off, release the switch trigger.
TOOL-LESS WHEEL GUARD
See fi gure 11 and 12.
Release the wheel guard lock lever, then turn the tool-less
wheel guard to the desired position. The maximum turning
-1
angle is 90° on either side; otherwise, the guard cannot
be locked.
VARIABLE SPEED DIAL
See fi gure 5.
A variable speed dial is separated with the trigger switch.
You can select different speed by adjusting this dial. To
have the lowest speed application, turn the dial to "1". To
have full speed application, turn the dial to "Max".
Never become complacent while using your grinder
sander, as carelessness can result in serious personal
injury.
MOUNTING THE GRINDING WHEEL
See fi gure 6 and 7.
Inspect grinding wheel before installing. Do not use
broken or defective parts.
1. Unplug the tool.
Failure to unplug the tool could result in accidental
starting causing possible serious personal injury.
2. Attach the disc fl ange, the grinding wheel and the
clamp nut to the spindle shaft.
3. Ensure that the wheel is correctly seated over the boss
on the disc fl ange and clamp nut.
4. Depress the spindle lock button located at the right
side of the gear case.
5. Using the wrench provided, tighten the clamp nut in a
4
WARNING
WARNING