Advertisement
Available languages
Available languages
GB
3.3
ATTACHING THE SANDPAPER
1. Release the clamp grip then insert the sandpaper with the grit side facing out, as shown in fig. 2.
2. After inserting and stretching the sheet, lift up the clamp lever making sure the teeth of the clamp grip the paper correctly.
3. Wrap the sheet around the length of the pad and attach the free end of sheet under the clamp on the opposite side and
repeat the procedure stated above. For efficient sanding, the sandpaper must be drawn as tightly as possible, as a
loose sheet can slip on the work surface.
3.4
USING THE PUNCHER
If the sheet of sandpaper has not been punched, you can use the puncher supplied with the tool to punch dust collection
holes in the sandpaper. Align the sanding pad with the puncher and push down on the sander until the puncher pierces the
sandpaper. Then remove the puncher from the sander. See Fig. 3.
3.5
SANDING
Do not apply excessive pressure on the sander when sanding. Excessive pressure may result in uneven sanding and cause
overheating which could damage the motor.
Do not sand in the same spot for too long. Otherwise uneven sanding will result.
4.
MAINTENANCE
4.1
CARBON BRUSHES
The tool's brushes and commutator must be checked regularly (once every few months) at an Authorised Ryobi Service
Centre. Good contact between the brushes and commutator is required for the tool to operate properly. The carbon brushes
must be replaced when an abnormally big spark is produced around the commutator.
4.2
CLEANING
Before cleaning or carrying out any maintenance, disconnect the tool from the power supply. The best cleaning method
consists in using dry compressed air. Always wear safety goggles when cleaning tools with compressed air.
Ventilation slots and switches must be kept clean at all times. Do not insert pointed objects through the slots to try to clean them.
Never use any chemical products to clean the tool.
5.
ACCESSORIES
See Fig. 4.
•
SANDPAPER
•
DUST BAG
•
PUNCHER
•
DUST NOZZLE
6.
WARRANTY
All Ryobi products are guaranteed against manufacturing defects and defective parts for a period of twenty four (24) months
from the date stated on the original invoice drawn up by the retailer and given to the end user.
Deterioration caused by normal wear and tear, unauthorised or improper use or maintenance, or overload are excluded from
this guarantee as are accessories such as battery packs, light bulbs, blades, fittings, bags, etc.
In the event of malfunction during the warranty period, please take the NON-DISMANTLED product, along with the proof
of purchase, to your retailer or nearest Authorised Ryobi Service Centre.
This warranty in no way affects your legal rights concerning defective products.
7.
SPECIFICATIONS
Voltage
No load speed
Wattage
Orbit diameter
Pad size
Sandpaper size
Noise
Vibration
9 pcs (A)
1 pc (B)
1 pc (C)
1 pc (D)
: 230 V - 240 V
: 12,000 min
-1
: 220 W
: 1.6 mm (~0.063")
: 185 mm x 90 mm (~7.3" x 3.5")
: 227 x 93 mm (~8.9" x 3.66")
: 82 dB
: 5 g
10
Advertisement
