Maintenance - Ryobi EAG85125RG Owner's Operating Manual

clockwise direction.
MOUNTING THE SANDING PAD
See fi gure 8.
1. Unplug the tool.
2. Attach the sanding pad to the spindle shaft. Disc
fl ange and clamp nut are not necessary for this
sanding application.
3. Depress the spindle lock button on the right hand side
of the gear case.
4. Tighten the sanding pad in a clockwise direction by
hand.
NOTE: Do not use sander without sandpaper. Doing so
will damage the cushion.
GRINDING
See fi gure 9.
The key to effi cient operation is controlling the pressure
and surface contact between the grinding wheel and
workpiece. Flat surfaces are ground at an acute angle,
usually 15 to 20 degrees with the workpiece. Allow the
wheel to reach full speed before starting to grind. Too
great an angle causes concentration of pressure on a
small area which may gouge or burn workpiece.
SANDING
See fi gure 10.
Choose sanding paper carefully for each application
for best operation and fi nish. The wheel guard can be
removed or kept as it is during sanding, but it is suggested
to keep the wheel guard on.
To have the best sanding result, it is recommended to
work with lower speed. Refer to the table for the proper
speed selection.
Application
Sanding
Grinding
The no-load speed for the sanding pad is 8000 rpm
(maximum).
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.

MAINTENANCE

After use, check the tool to make sure that it is in good
condition.
Speed setting
1 - 3
4 - Max
WARNING
It is recommended that you take this tool to a Ryobi
authorised service center for a thorough cleaning and
lubrication at least once a year.
Do not make any adjustments while the motor is in
motion.
Always disconnect the power cord from the socket
before changing removable or expendable parts
(grinding disc, sanding pad, sanding paper etc.), before
lubricating or working on the unit.
If the supply cord is damaged, it shall be replaced by
the manufacturer or its service agent or similar qualifi ed
person in order to avoid a hazard.
To ensure safety and reliability, all repairs should be
performed by an authorised service center or other
qualifi ed service organisation.
5
WARNING
WARNING